How it works
One outdoor unit, two independent rooms
Two neat pipe runs connect the outdoor unit to each room. You only need one unit on the outside wall instead of two — tidier, and usually simpler to place.
Illustrative only — unit positions and pipe routes are agreed with you at the survey.
What you get
Built for UK homes, all year round
Heating as well as cooling
An air-to-air heat pump, so it warms the room in winter as well as cooling it in summer. The manufacturer quotes heating operation down to −20°C outside.
Quiet indoors
Indoor units go as low as 22 dB(A) in quiet mode — the quietest of seven fan settings, designed for bedrooms at night.
Control from your phone
Wi-Fi built into both indoor units. Set each room separately from the app, or use the handheld remote.
Winter-ready outdoor unit
A built-in base pan heater helps stop ice building up in the outdoor unit during cold-weather heating.
Inverter efficiency
A full DC inverter compressor speeds up and slows down to match demand, rather than switching on and off. Rated A++ for cooling and A+ for heating.
R32 refrigerant
Uses R32, the refrigerant now standard in modern split systems, with refrigerant leak detection built in.
Specification
ZERO 1-to-2 multi-split
| Outdoor unit | ZERO ZSOV-18HDTA-EU (1-to-2 multi-split) |
|---|---|
| Indoor units | 2 × ZERO ZMSA-09HVT-EU-I wall-mounted, 9,000 Btu/h each |
| Total cooling capacity | 5.1 kW (17,400 Btu/h) |
| Total heating capacity | 5.2 kW (18,000 Btu/h) |
| Seasonal cooling efficiency | SEER 6.1 |
| Seasonal heating efficiency | SCOP 4.0 (average climate) |
| Indoor sound pressure | From 22 dB(A), quiet (mute) mode |
| Outdoor sound power | 65 dB(A) |
| Outdoor operating range | Cooling up to 53°C · heating down to −20°C |
| Refrigerant | R32, factory-charged 1.1 kg |
| Controls | Wi-Fi app and handheld remote, independent per room |
| Power supply | 220–240 V single phase |
Figures are from the manufacturer's published data. Energy classes are seasonal ErP ratings; the heating class shown is for the average European climate zone. Sizing for your rooms is confirmed with a heat-load check at survey.
The installation
What's included, and what we check at survey
Included as standard
- Both indoor units and the outdoor unit, supplied and fitted
- Outdoor unit mounted on wall brackets or a ground stand
- Standard pipe runs, neatly routed and covered in trunking
- Wall cores drilled and sealed, condensate drainage
- Electrical connection, tested and certificated by a qualified electrician
- Pressure test, evacuation and commissioning by an F-Gas certified engineer
- App set-up and a walk-through of the controls before we leave
Confirmed at survey
- Longer pipe runs, or rooms on opposite sides of the house
- Access equipment for high or awkward walls
- Whether a new electrical circuit is needed
- Outdoor unit position, noise and neighbours
- Any planning considerations for your property
You get a fixed written quote after the survey, so anything extra is agreed before any work starts.
Questions
Common questions
Can I use just one room at a time?
Yes. Each indoor unit has its own controls, so you can run one room, both, or set them to different temperatures.
Do the two rooms need to be next to each other?
No, but rooms close to the outdoor unit keep the pipe runs short and the installation simpler. We'll look at the layout with you at survey.
Can one room heat while the other cools?
No — like most multi-splits, both rooms run in the same mode at once (both heating or both cooling). Each room can still be set to its own temperature.
How long does the installation take?
A straightforward two-room install is usually completed in a day. We'll give you a firm timescale with your quote.
Will I need planning permission?
Many installations don't, but it depends on your property and where the outdoor unit goes. We check this, along with noise and neighbouring homes, before we quote.
Get a quote
Is a two-room system right for your home?
Send us your postcode and a few photos and we'll tell you. Our first 20 systems are arriving now, and early enquiries get first choice of install dates from early 2027.